stertil-KONI ST 1055 Installation, Operation & Service Manual page 13

- Keep hair, loose clothing, fingers and all parts of the body away from moving parts.
- To reduce the risk of electrical shock, do not use on wet surfaces or expose to rain.
- Use only as described in this manual. Use only manufacturers recommended attachments.
- ALWAYS WEAR SAFETY GLASSES. Everyday eyeglass only have impact resistant lenses, they are not
safety glasses.
- Use by untrained people could result in serious injury and/or damage.
- Do not use the lifting system outdoors if the wind velocities mentioned in paragraph 5.5 are exceeded
- If the lifting system is used outdoors do not leave the vehicles unattended in the lifted position. The wind
speed may change and exceed the safety limits.
- Danger of getting injured by electrical shock.
- Only remove the covers to carry out maintenance, ensure that the lifting system is disconnected from the
power supply.
- Care must be taken as burns can occur from touching hot parts.
- Prevent damage to the power feed cables on account of driving over or heavy or falling objects.
- Do not drive over interconnecting cables. Always disconnect interconnecting cables and remove from
vehicle travel path before moving vehicle.
- Do not operate equipment with a damaged cord or if the equipment has been dropped or damaged until it
has been examined by a qualified serviceman.
- In case of using one or two lifting columns (in paired operation), be sure that this will not result in stability
risks. In case of doubt, consult your superior. Unsafe lifting can result in serious injury and damage to the
lifting system and/or vehicles.
- This lifting system should only be used for lifting of vehicles and not for other applications. The positioning
of the lifting system must be done in a way that a safe working area will be obtained above and around the
lifting columns, thereby creating escape paths for emergency situations (leave passageways of at least 600
mm, 24").
- If a vehicle is in the lifted position, its air suspension system may not be used in a view of possible change of
track width and/or wheel base.
- Use the lifting columns only on a hard and level floor with sufficient bearing capacity,
see 1.2 Specifications for floor pressure and floor load.
- Once desired height has been reached, it is recommended but not required that the lift be lowered into the
mechanical locks.
SAVE THESE INSTRUCTIONS
8