Advertisement
Please do not use third-party adapter to recharge the unit.
The same charge through ports A, B, C, D.
During charging, light is red.
On full charging of device, light is green.
Assembly holes
2. Adaptor
3. Motor
Gear axis
Steps to turning the robot on
When the robot turning on, it`s necessary to pay attention to several points:
1. Select a space and a flat surface.
2. Put robot to selected surface vertically.
3. Press the power button to turn on the device. Mitu (Bunny) Block Robot automatically
adjust the center of gravity and keep the balance.
Switching on: Press the power button.
Switching off: Press the power button and hold for 3 seconds until you hear the special
beep.
Note: Before turning on, please place the unit as much as possible perpendicular to a
surface. In determining the center of gravity, and if you want a little support Mitu (Bunny)
Block Robot, to prevent falling. Mitu (Bunny) Block Robot automatically finds and holds a
balance.
Advertisement
