Preparation; Connecting The Power; Attaching The Cord; Connecting Other Equipment - Tascam MZ-223 Owner's Manual

Cord holder
;
Attach the power cord of the included AC adapter
(TASCAM PS-M1524) here to prevent accidental
disconnection. (See "Connecting other equip-
ment" on page 10.)
DC IN 15V connector
z
Connect the DC plug of the included AC adapter
(TASCAM PS-M1524) here.
MONITOR OUT jacks
x
These RCA pin jacks are analog monitoring out-
puts.
MAIN OUTPUTS 1–3 (BALANCED) jacks
c
These analog outputs are XLR jacks. (1: GND, 2:
HOT, 3: COLD)

Preparation

Connecting the power

Use the included AC adapter (PS-M1524) to connect a
power supply to the unit as shown below.
Power outlet
DC plug
CAUTION
Always use the AC adapter (PS-M1524) that was
shipped with the unit. Using a different AC adapt-
er could cause malfunction, overheating, fire or
other problems.
NOTE
The AC adapter for the unit includes two types of
adapter cords. Attach the type of AC adapter cord
that matches the power outlet that you are using.

Attaching the cord

In order to prevent the cord from becoming discon-
nected during use, attach it to the cord holder (
when connecting it to the unit.
10
TASCAM MZ-223
TASCAM
PS-M1524 (included)
Use the ATTENUATOR (
output levels.
MAIN OUTPUTS 1–3 (UNBALANCED) jacks
v
These RCA pin jacks are analog outputs.
Use the ATTENUATOR (
output levels.
LINE A/B input jacks
b
These RCA pin jacks are analog line outputs.
Record players can be connected to the LINE A
input jacks of channels 1–2. When connecting
a record player to these jacks, also connect its
grounding wire to the | (GND) jack (
the LINE/PHONO input selection switch (
PHONO.
1.
Remove the cord holder (
2.
Place the cord in the cord holder (
3.
Tighten the cord holder (

Connecting other equipment

This is an example of MZ-223 connections.
Precautions before making connections
0 Carefully read the operation manuals of the de-
vices to be connected and then connect them
correctly.
0 Before making connections, turn this unit and all
equipment to be connected off (standby).
0 Install all connected devices, including this unit, so
that they are powered from the same line. When
using a power strip or similar device, be sure to
use one that has high current capacity (thick ca-
ble) in order to minimize fluctuations in power
voltage.
0 When connecting audio devices, minimize the
channel 1-5 GAIN knobs (
the OUTPUT VOL (
knobs. Failure to do so could cause sudden loud
noises from monitoring equipment, and this could
damage the equipment or harm hearing.
)
;
) switches to change the
h
) switches to change the
h
), and set
k
) screw.
;
).
;
) screw.
;
) and faders (
j
) and PHONES VOLUME (
q
) to
l
), and
8
)
a