1. General information 1.1 Information about the instruction manual This instruction manual contains information about the installation, operation and maintenance of the device and should be consulted as an important source of information and reference guide. Awareness of the safety instructions and instructions for use in this manual will ensure the safe and correct use of the device.
1.3 Liability and Warrantees All the information and instructions in this manual take into account standard safety regulations, current levels of technical engineering as well as the expertise and experience we have developed over the years. The instruction manual was translated with all due care and attention. However, we do not accept liability for any translation errors.
2. Safety This section provides an overview of all important safety aspects. In addition every chapter provides precise safety advice for the prevention of dangers which are highlighted by the use of the above mentioned symbols. Furthermore, attention should be paid to all pictograms, markers and labels on the device, which must be kept in a permanent state of legibility.
CAUTION! o The device is not intended for use by individuals (including children) with physical or mental disabilities, insufficient experience, and/or insufficient knowledge unless such persons are under the care of a person responsible for their safety or have received instructions regarding appropriate use of the device.
3. Transport, packaging and storage 3.1 Delivery check Please check the delivery upon completeness and transport damage immediately after receipt. In case of visible damage do not accept or accept the delivery with reservation only. Note the extent of damage on the carrier’s bill of delivery. Trigger off the complaint. Hidden damages should be reclaimed immediately after notice, as claims for damages can only be asserted within the effective period for complaints.
4. Technical data 4.1 Overview of parts ③ ④ ① ② ⑦ ⑤ ⑥ ⑧ ⑨ ④ ① Engine ② ⑩ Transparent lid ③ Filling port in the lid ④ Removable ice cream container ⑪ ⑤ Engine connector ⑥ Stirring staff ⑦...
• Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep away the cable from operating range and do not dunk it into water. • Do not move or tilt the device when in operation. WARNING! Hazard via electrical current! The device can cause injuries due to improper installation! Before installation the local power grid specification should be compared with...
5.3 Operating Preparing the device • Prior to first use, wash all parts of the device that will be in contact with food products with warm water and a mild cleaning agent (transparent lid, filling port, ice cream container, stirring staff, measuring cup, ice cream scoop). Rinse all parts in clean water and dry thoroughly.
Page 12
Control panel Ⓐ Ⓑ Ⓒ Ⓓ Ⓔ Ⓕ Ⓐ Cooling control light (red) Ⓑ Digital display Ⓒ Mixing control light (green) Ⓓ POWER (on/off button) Ⓔ START/STOP button Ⓕ TIMER Preparing ice cream • Connect the device to an appropriate single power socket. •...
Page 13
• When the set time is reached a signal tone resounds and the device stops making ice cream off automatically. Ice cream preparation is finished. • If the device is not activated within 10 minutes, it automatically enters into cooling mode and the compressor cools for the next 10 minutes.
Page 14
Settings while the device is operating • The ice cream making process can be interrupted by pressing the START/STOP button for three seconds, or by pressing POWER. To reactivate the device, start from the beginning and reset the time by pressing the button marked TIMER. •...
• In order to sweeten the ice cream during the preparation/production process, do not add the sugar or sweetener directly into the ice cream container (it will not dissolve). Instead dissolve the sugar in a bit of water or low-fat milk and pour the syrup (cooled) into the ice cream container.
6.2 Cleaning o Clean the device regularly. o Wash all parts of the device that come into contact with food products thoroughly (transparent lid, filling port, ice cream container, stirring staff, measuring cup, ice cream scoop), using warm water and a mild cleaning agent. Rinse them in clean water to remove all traces of cleaning products.
NOTE! For the disposal of the device please consider and act according to the national and local rules and regulations. Bartscher GmbH Franz-Kleine-Str. 28 D-33154 Salzkotten phone: +49 (0) 5258 971-0 Germany fax:...