Bissell QUICKSTEAMER 2080 Series User Manual page 6

Operations
pre-treating
Pre-treat stubborn stains and highly soiled
carpet in hallways and other high-traffic areas.
1. Generously spray bissell stain PreTreat even-
ly over soiled area. DO NOT OVERWET CARPET.
2. Wait 3-5 minutes before deep cleaning.
carpet cleaning
1. Turn the unit ON by using your foot to depress
the red power switch located on the foot of the
machine.
2. With your foot, press the detent lever located
to the right of the power switch.
3. Depress trigger to spray cleaning solution,
while moving machine forward over soiled area
Do not overwet.
4. To suction up water, repeat motion over same
area without pressing trigger.
5. Repeat steps 3 and 4 until no more dirt can be
removed.
6. Continue to clean entire carpet, working in
3' x 4' sections.
7. empty the collection tank when dirty water
reaches the full line, or when the solution tank
is empty.
8. if floor nozzle stops spraying, turn power
OFF
switch
and check water and cleaning
solution levels. Refill if needed.
to empty the collection tank
1. Turn power switch OFF and unplug power
cord from outlet.
2. Remove and empty collection tank.
a. Release collection tank latches [1 each side]
by pulling up from bottom of latch and then
out.
b. Carefully remove collection tank from
lower body by lifting handle.
c. Carry collection tank to a toilet or sink. To
empty, pour out contents using opening
at back of tank.
d. Rinse collection tank thoroughly.
e. Remove lint and hair from red gasket in
base of unit. (Do not remove gasket)
www.bissell.com
6
2a.
2c.
800.237.7691
Tip
» It is recommended that every
time your solution tank needs
refilling that you empty the con-
tents of the collection tank. If the
collection tank gets too full, you
may begin to see foam spitting out
of the vent cover. If this happens,
empty the collection tank.
2b.
2e.