Advertisement
2
Installing the phone in the helmet and installing
the APP
- Make sure your phone is connected to the Internet, turn on WiFi
- Insert the phone into the Type C slot with the back side to the top
- Put on your helmet. After viewing the reminder about the installation,
remove the phone, the APP installation is complete
- Open the APP, following the manual, complete the download
Attention: after inserting the phone into the helmet, you can see
automatic prompts for installing the Mi VR Helmet APP. If you did not
see such notifications, please update the MIUI system to the correct
version. Before scanning the QR code shown on the front panel, make
sure that the phone model and operating system version meet the
requirements of the Mi VR helmet.
Phone installation:
1) Insert the phone into the Type C slot with
the back side to the top
2) Release the lock on the right side to the
right to the limit
3) Insert the phone into the helmet, then
release the latch
Pulling out the phone:
4) Release the latch on the right side to the
right to the limit (in this case, the phone can
automatically jump out a little)
5) Lift the phone, then release the latch
6) Remove the phone from the Type C slot
Immerse yourself in the virtual reality world:
1. After completing all the settings, insert the phone into the Mi VR helmet.
2. Properly attach the device:
1) Before using the helmet, remove
both protective film from the lens
3) Put your helmet on your head.
Make sure that your eyes are
flush with the lenses, press your
forehead firmly against the foam
headband, and then lower the
headrest downwards
2) The head restraint must be in the
highest possible position
4) Remove the protective film before
use. Press the head restraint button
to adjust the length of the straps.
Release the button to lock the current
position of the head restraint.
Advertisement
