Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Thermon Manuals
  4. Security System
  5. Terminator ZE-B Beacon
  6. Installation procedures

Thermon Terminator ZE-B Beacon Installation Procedures

Led end of circuit light kit
Hide thumbs
1
2
3
4

Advertisement

Quick Links

Download this manual
Terminator
ZE-B Beacon
TM
LED End of Circuit Light Kit

Advertisement

loading
Need help?

Need help?

Do you have a question about the Terminator ZE-B Beacon and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Thermon Terminator ZE-B Beacon

Summary of Contents for Thermon Terminator ZE-B Beacon

  • Page 1 Terminator ZE-B Beacon LED End of Circuit Light Kit INSTALLATION PROCEDURES...
  • Page 2 Light Module Cover 3. Identify parts against the packing list to ensure the proper type and quantity has been received. Banding Guide 4. Store in a dry location. Banding LED Light Module Installation Precautions • To minimize the potential for arcing and fire caused by product damage Order Separately or improper installation use ground-fault protection. SCTK Connection Termination Kits (per cable) • Installation must comply with Thermon requirements and be installed in accordance with the applicable national and local codes. SCTK-1 for BSX, RSX, VSX-HT • Component approvals and performance ratings are based on the use SCTK-2 for KSX, HTSX of Thermon specified parts only. • De-energize all power sources before opening enclosure. SCTK-3 for FP, HPT • Keep ends of heating cable and kit components dry before and during installation.

  • Page 3: Installation Procedures

    INSTALLATION PROCEDURES 300 mm (12") 50 mm Weep Hole (2") Max. Connection Locate bus connection (HPT and FP only) and Insert cable into expediter. If mounted Slide expediter toward pipe and route cable cable as shown. Cut end of cable at angle to aid on bottom of pipe, punch out weep hole. through support base entry. in piercing grommet. Leave additional cable for Note: For HPT and FP cable, exchange grommet expansion loop. in Terminator with GRW-G provided in PETK-3. 101 mm (4") Min.
  • Page 4 8 mm (.32") When using SCTK-TB Connection Kit, first trim Use the terminal block mounting screw to Connect the bus wires of the trace heater to exposed bus wires of the LED pigtail to 8 mm mount terminal block to the LED light module. the terminal block. (.32"), then connect to the terminal block. Bend each pigtail lead around the sides of the terminal block. Unlocked Position Locked Position Engage threads. Rotate light module cover To remove cap, de-energize circuit, lift latch clockwise and tighten cap securely. Make sure mechanism, and unscrew cap. latch mechanism is in the locked position. Corporate Headquarters: 100 Thermon Dr • PO Box 609 San Marcos, TX 78667-0609 • Phone: 512-396-5801 • 1-800-820-4328 For the Thermon office nearest you visit us at . . . www.thermon.com Form No. PN50844-0918 © Thermon, Inc. • Printed in U.S.A. • Information subject to change.