Image Menu - Hitachi CP-X608 Operating Manual

IMAGE Menu

IMAGE Menu
From the IMAGE menu, items shown in the table below
can be performed.
on the projector or remote control, or ENTER button on
the remote control to execute the item. Then perform it
according to the following table.
Item
ASPECT
OVER SCAN
V POSITION
H POSITION
(continued on next page)
30
For an RGB or MIU signal
NORMAL 4:3
For an M1-D signal
NORMAL 4:3
For a Video signal, S-video signal or Component video signal
4:3 16:9 14:9
For no signal
• The NORMAL mode keeps the original aspect ratio of the signal.
Large (It reduces picture)
• This item can be selected only for a video, s-video and component signal.
• When this adjustment is too large, certain degradation may appear
at the frame area of the picture. In such a case, please adjust small.
Up Down
• Over-adjusting the vertical position may cause noise to appear on the screen. If this
occurs please reset the vertical position to the default setting. Pressing the RESET button
when the V POSITION is selected will reset the V POSITION to the default setting.
• When this function is performed on a video signal, s-video signal, or
component video signal of 525i (480i) or 625i (576i), the range of this
adjustment depends on the OVER SCAN (
possible to adjust when the OVER SCAN is set to 10.
Left Right
• Over-adjusting the horizontal position may cause noise to appear on the screen. If this
occurs please reset the horizontal position to the default setting. Pressing the RESET
button when the H POSITION is selected will reset the H POSITION to the default setting.
• When this function is performed on a video signal, s-video signal, or
component video signal of 525i (480i) or 625i (576i), the range of this
adjustment depends on the OVER SCAN (
possible to adjust when the OVER SCAN is set to 10.
Description
16:9 SMALL
16:9 14:9 SMALL
SMALL
above) setting. It is not
above) setting. It is not