Connection Tips For Superior Sound; Ert/Erm/Erd Standard Connection Diagrams - Emotiva ERT Series Operation Manual

Sound
Before setting up your home entertainment system, please consider the following:
•
Whenever possible, route the power cords away from the signal cables or speaker wires to prevent
any hum or interference heard in the speakers.
•
Many audiophile signal and speaker cables are intended to be hooked up in one direction. If this is
the case, the cables will be marked with arrows the direction of signal flow.
•
ALWAYS observe the correct polarity for speaker wiring, both at the amplifier output and at the
speaker itself. This is a key point to great sound.
•
Should you have any questions about connection or configuration of any Emotiva products, visit
the SUPPORT section of the Emotiva website or call us directly at (877) EMO-TECH

ERT/ERM/ERD Standard Connection Diagrams

Connect the positive output of the amplifier to the positive speaker binding post. Connect the negative
output of the amplifier to the negative binding post. Repeat for the opposite channel. On the ERT-
8.3/ERM-6.3/ERM-6.2/ERM-1 it does not matter which set of binding posts you choose because the
shorting bars will be left installed between posts in this configuration.
Connect to appropriate amplifier channel (i.e. Left, Center, Right, Left Surround, Right Surround, etc.)
observing correct polarity.
ERT-8.3/ERM-6.3/ERM-6.2 Bi-Amp Connections
21