Bunker Hill Security 64945 Owner's Manual & Safety Instructions page 5

6. Use a Wire Nut (13) to connect the
black "hot" wire from the light fixture to the
"hot" wire from the building's wiring.
WARNING! If the building's wiring is colored
differently, consult a licensed electrician and
your local building code for direction.
7. Use a Wire Nut (14) to connect the
white "neutral" wire from the light fixture to the
"neutral" wire from the building's wiring.
8. Connect the ground wire from the building's wiring to
the Green Screw (17) on the back of the light fixture.
"neutral"
wires
"hot" wires
9. WARNING! Carefully check that all wiring
is properly secured before proceeding.
Item 64945 64946
Wire Nuts
(13, 14)
ground
wire Screw (17)
Figure C
For technical questions, please call 1-888-866-5797.
10. Hold the light fixture, then disengage and
remove the Temporary Hanger (20).
11. Place the Gasket against the outlet box, carefully
fit all wiring connections into the outlet box, then
place the Main Housing against the Gasket.
Secure the Main Housing using a Mounting Bolt (10).
Push the Bolt Cover (8) firmly into the center hole.
12. Caulk around the Base and mounting surface
with silicone sealant (not included).
13. Align the three slots on one of the Lampshades (1)
to the three tabs on one of the Lamp Housings (5),
Green
insert it, and twist it clockwise to secure it.
Repeat for the other Lampshade and Lamp Housing.
Lamp
Housing (5)
14. Install two 150W PAR38 bulbs, one into each
Socket. Do not leave either Socket empty.
WARNING! Risk of fire. Do not install bulbs of
higher wattage or bulbs of a different type/shape.
15. After carefully checking that the light is properly
secured, turn the power back on to the circuit.
Mounting
Bolt (10)
Figure D
Lampshade (1)
Figure E
Bolt
Cover
(8)
Page 5