Bunker Hill Security 64945 Owner's Manual & Safety Instructions page 4

Installation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
DANGER! TO PREVENT SERIOUS INJURY AND DEATH FROM ELECTRIC SHOCK: Disconnect power supply
to circuit at breaker box and mark that breaker clearly to ensure it is not turned on during installation.
1. Determine the mounting location - wall or
eave mount. Position the Light Fixture in the
general direction of the desired light coverage.
Rotate the Motion Sensor so the controls
face the ground after installation.
Note: Do not install the Light Fixture upside-
down, with the Motion Sensor on top.
CAUTION! Do not cut or disconnect
any wiring within the fixture.
2. Remove any existing fixture.
WARNING! Use a voltage tester (sold
separately) to ensure circuit's power is
disconnected before proceeding.
Note: For ease of use, wiring this light to a circuit
that includes a manual switch is recommended.
3. Turn the bracket so that the side marked
FRONT faces you. Install the Bracket using the
Bracket Screws that fit the outlet box. Firmly pull
on the Bracket to verify it is securely mounted
to the outlet box. If necessary, use the screws
that were removed from the existing fixture.
Page 4
Bracket Screws
(new or existing)
Figure A
For technical questions, please call 1-888-866-5797.
4. Route the loose wires from the fixture
through the Gasket (12).
5. Insert the Temporary Hanger (20) through the
center hole of the Fixture and the center hole of
the Gasket, and hang it in the cutout on one of the
side holes of the Bracket. This will help limit the
strain put on the wiring while making connections.
side hole
cutout
Bracket
Bracket
Gasket
Figure B
fixture
Temporary
Hanger
Item 64945 64946