Table of Contents
Advertisement
PARTS
1. On/off switch
2. Intercept trimmer
3. Shaving foils
4. Hair pocket
5. Charging indicator
GETTING STARTED
CHARGING YOUR SHAVER
10. Ensure the product is switched off.
11. Connect the charging stand to the adaptor and then to the mains.
Charging indicator
Charge Level
Charging
Low charge
Full charge
•
Run time from fully charged is up to 60 minutes.
•
Charge time from empty is 2 hours.
•
To preserve the life of your batteries, let them run out every 6 months then recharge
for 24 hours.
INSTRUCTIONS FOR USE
It is recommended that you use your new shaver daily for up to four weeks to allow time
for your beard and skin to become accustomed to the new shaving system.
Shaving
12. Switch the shaver on by pressing the on/off switch.
13. Stretch the skin with your free hand so the hairs stand upright.
14. Hold the shaving head so that the foils touch your face.
15. Use short, linear strokes.
Shaving with shaving gel
Follow the same instructions as dry shaving if using shaving gel.
Caution: After use with shaving gel, please rinse the blade under warm water to clean
away any excess gel and debris.
4
6. Charging connector
7. Pop-up trimmer (on back)
8. Foil assembly release buttons
9. Face towel (not shown)
Indicator
LED flashes slowly
LED flashes quickly
LED comes on for 5 minutes then goes off
Advertisement
Table of Contents
