Advertisement
Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth.
2. Familiarize yourself with the pump. The pump speed is controlled by the switch located
at the front of the pump. The speed is indicated by a plus (+) and minus (-) sign. To
increase the speed, move the switch slowly in the direction of the plus sign. You will hear
a click as the switch moves to each speed level. At its highest speed level, the switch will
cease to move any further. To decrease the pump speed, move the switch toward the
minus sign. Similarly, at its lowest speed, the switch will cease to move any further.
NOTE: It is recommended the pump be set at its highest speed during assembly and
later adjusted to a lower setting if desired. Be sure to unplug the pump before adjusting
the speed setting.
Figure 1
Lights
Fountain Top
Platform
Adaptor
Base
ON/OFF
Switch
Glass Stones
Tube
Pump
Cord Slot
4
3. Insert the pump into the tube on the bottom side of the fountain top (Fig. 2).
Figure 2
Tube
Insert tube
into pump
Pump
4. Fill base with tap water to 1" from top. We recommend using distilled water to
prevent mineral build up (Fig. 3).
Figure 3
Fill with water
1" from top
5
Advertisement
