Table of Contents
Advertisement
2
TippingPoint Hardware Safety and Compliance
This document describes TippingPoint product regulatory compliance and provides safety requirements and
warnings.
Overview
Before installing your TippingPoint product, you must read through all preparation instructions and safety
requirements.
Safety and Compliance Requirements
For detailed regulatory compliance information, refer to the HP TippingPoint Hardware Safety and
Compliance Guide, available on the TMC and included with your product.
Safety Guidelines and Warnings
Before you start the installation procedures, read this entire section for important information and safety
warnings.
If not properly installed and maintained, electrical circuitry equipment can pose dangers to both personnel
and equipment. To prevent accidents, adhere to the following guidelines to ensure general safety:
•
Remove any dust from the area and keep the area around the product clear and dust-free during and
after installation.
•
Wear safety glasses if you are working under conditions that might be hazardous to your eyes.
•
This product has serviceable modules and hot-swappable power supplies. It has no other serviceable
parts inside.
Cautions
Cautions tell you how to avoid a serious loss that stops short of physical damage such as the loss of data,
time, or security. Cautions tell you what you should or should not do to avoid such losses, and the
consequences of not heeding the caution.
CAUTION:
Do not power up the equipment while you install and connect the system.
If you connect the power improperly and then apply power, the cards and chassis could be damaged.
You are responsible for installing an AC power disconnect for the entire rack unit. This main disconnect
must be readily accessible, and it must be labeled as controlling power to the entire unit, not just to the
server.
TippingPoint 10/110/330 Hardware Installation and Safety Guide
7
Hide quick links:
Advertisement
Table of Contents
