National TESSERA RETURN Assembly Instructions

1
If not previously completed, make sure main desk is positioned and leveled in its
final location prior to assembly of return.
2
Remove two flat brackets from the bottom of the shroud to access the interior as
needed. Brackets can be discarded (Figure B) as they are only installed to protect
during shipping.
NOTE: Removable panel hangs from Z-clip brackets. Once flat brackets are
removed care should be taken so that the panel does not disengage from Z-clip and
damage the component.
3
Install the glides (Qty. 4) from the hardware kit to the bottom of the shroud
(Figure C).
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service
Figure A
Figure B
Figure C
Assembly Instruction
TESSERA RETURN
INSTALL
Tools Required
-Screw Driver w/ #2 Phillips Bit
-Level
-Cable Ties
Hardware
-Glides
-PHP #8x1
Telephone 800.482.1717
Fax 812.482.8800
www.NationalOfficeFurniture.com
3206400
Rev, -
.
800.482.1717
x 4
x 25