mothercare Pop Cabin Bed User Manual

Enlarged version

care of your product

Periodically check all fittings to ensure that none have come loose.

The bed can be cleaned by wiping with a damp cloth and drying with a soft dry cloth.

Never clean with abrasive, ammonia based, bleach based, or spirit type cleaners.

Take care when handling or moving the bed.

Careless handling can damage wooden furniture.

All Assembly fittings should be tightened properly and regularly checked for security.

Be aware of the risk of open fire and other sources of strong heat, such as electric bar fires, gas

fires, etc. in the near vicinity of the wardrobe.

your child's safety is your responsibility

If you have a problem with this product or require replacement parts,

please contact your nearest Mothercare store or telephone the

Mothercare customer care line on 08453 30 40 30

Alternatively write to:

Customer Care

Mothercare

Cherry Tree Road

Watford

Herts. WD24 6SH

www.mothercare.com

Pop

Cabin Bed

user guide

IMPORTANT - READ CAREFULLY AND KEEP FOR FUTURE REFERENCE

Table of Contents

Do you have a question about the Pop Cabin Bed and is the answer not in the manual?

Page 1 If you have a problem with this product or require replacement parts, please contact your nearest Mothercare store or telephone the Mothercare customer care line on 08453 30 40 30 Alternatively write to:...
Page 2 fig 12 important notes fig 12.1 Please take a few minutes to read this user guide. Lay the parts out on the floor and compare to the PARTS CHECK LIST (below). Do not discard any packaging until you are sure that you have all the parts. You will need the aid of a second person at certain stages of assembly.
Page 3 fig 11 fig 3 Attach the middle panel to the back board by inserting 3 large Screw 3 small cam pins and four dowels into each drawer front and place two drawer cam pins into the three small sides and one drawer brace onto each front ensuring that all cam pins are correctly parallel holes on one side of the engaged into their corresponding holes on the edges of each part (shown below).
Page 4 fig 9 fig 6 Insert 4 bolts (16mm) into each of Attach the foot to the underside of the the pre-fitted metal inserts in each base panel using 2 screw bolts (50mm) end. Ensure the bolts are only as shown left. screwed in half way so that they are easier to locate onto the brackets.