Versalift VO-452-MHI Operator's Manual page 22

bearing. (The 40 in (1.0 m) height refers to the installed
height, measured from the top of the chassis frame to
the top of the pedestal.) This pedestal may be trimmed
at installation up to 6 in (15 cm) to obtain the desired
travel height and cab clearance.
46 IN TALL PEDESTAL - The pedestal is a fabricated
steel structure incorporating a 1.5" (38 mm) thick top
plate which is machined flat to support the rotation
bearing. (The 46 in (1.2 m) height refers to the installed
height, measured from the top of the chassis frame to
the top of the pedestal.) This pedestal may be trimmed
at installation up to 6 in (15 cm) to obtain the desired
travel height and cab clearance.
A-FRAME OUTRIGGERS - A-frame outriggers are
designed and constructed from high-strength steel.
The cross-beam is shipped loose to allow the desired
ground clearance and penetration to be determined
at installation. At maximum extension the outriggers
provide 158" (4.0 m) of spread and from 6" to 11" (15
cm to 28 cm) of penetration based on a 40" (1.02 m)
frame height. Outriggers are equipped with pilot
operated check valves, internal thermal relief valves,
and separate operating controls for each outrigger.
Slide pads at each leg ensure smooth operation. The
standard pivot feet swivel a minimum of 10
X-FRAME OUTRIGGERS, FLIP FOOT - X-frame
outriggers are designed and constructed from high-
strength steel. The mounting plates are shipped loose
to allow the desired ground clearance and penetration
to be determined at installation. At maximum
extension the outriggers provide 176.5" (4.5 m) of
spread and from 5" to 12" (13 cm to 30 cm) of
penetration based on a 40" (1.02 m) frame height.
Outriggers are equipped with pilot operated check
valves, internal thermal relief valves, and separate
operating controls for each outrigger. Slide pads at
each leg ensure smooth operation. The standard pivot
feet swivel a minimum of 10
RADIAL OUTRIGGERS - Radial outriggers are
designed and constructed from high-strength steel.
At 11" (28 cm) of penetration the outriggers provide
211" (5.4 m) of spread based on a 40" (1.02 m) frame
height. Outriggers are equipped with pilot operated
check valves, internal thermal relief valves, and
separate operating controls for each outrigger.
AUTOMATIC BOOM LATCH – The automatic boom
latch is designed to automatically restrain the upper
boom in the cradle when stowed and automatically
release the boom when the lift is operated. The latch
is actuated by a hydraulic cylinder and includes a
manual over-ride to open the latch without hydraulic
power.
VERSALIFT VO-452/455/460-MHI
each way.
0
each way.
0
3-4
PLATFORM TILT AT LOWER CONTROLS – An
additional lever at the lower control station operates
the platform stow/unstow function.
PLATFORM ELEVATOR (Single Platform Only) –
Hydraulically controlled platform elevator which will
raise the platform and control panel 24" at the boom
tip. Driven by a telescoping cylinder, the platform
elevator can be raised proportionally using the same
style control valve used for all boom function.
39049-01 01/17