Advertisement
Begin by removing the light and bracket from the box and orientate them as shown in the picture above.
1)
Locate the ¼"-20 and 3/8" hardware in the provided hardware pack, and place center 3/8" bolt and two ¼"-20 bolts and associated washers through the bottom of
2)
the bracket. Use provided washers and nuts below the mounting surface tighten down after alignment.
Mount the bracket to the light using the remaining ¼-20 hardware (4 bolts and 4 washers).
3)
Lens Swap Instructions (uService):
•
When installing a different lens simply remove the 6 allen head bolts using a 4mm allen wrench on the back of the of the light.
•
Carefully remove the front bezel and lens.
•
Make sure that the o-ring is properly fitted in o-ring grove in the housing when installing the new lens and bezel. The o-ring is not directional but its shape was
designed to match the grove in the housing.
•
Reinstalling the bezel will give you a brand-new lens and pattern, depending on your preference.
•
The bezel should be torqued to 7 ft./lb. in a "criss-cross" pattern.
1.
LP9 Wiring Instructions
The LP9 is able to run at 12-36 Volts.
o
Low beam, high beam and Amber Back light function off positive current.
o
Do NOT power pins 1 and 4 at the same time. This may cause damage to the circuit board!
o
If you are creating your own wiring harness the mating connector for the back of the light is a Deustsch Connector with part number DT06-4S. When you wire the light,
o
you cannot supply power to the low beam (pin 1) & the high beam (pin 4) at the same time. Use a three position toggle switch (on/off/on) that is single pole, double
LP9 Sport Wiring Instructions
Advertisement
