Pioneer VSX-834 Instruction Manual page 79

„ 2. Dolby
Change the setting of when Dolby signals are input.
Setting Item Default Value
Loudness On
Management
Center Spread* Off
* This function will become unavailable for selection if the firmware is updated after
purchase or the firmware is switched in the product production process. For details of
firmware update, see "Additional Function (Firmware Update)" (
Setting Details
When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume of
dialog at a certain level. Note that when this setting
is Off, the Midnight function that allows you to enjoy
surround at low volumes is fixed to off when playing
Dolby Digital Plus/Dolby TrueHD.
"On": When this function is used
"Off": When this function is not used
Adjust the width of the sound field of the front
channel when playing in the Dolby Audio - Surr
listening mode.
"On": To spread the width of the sound field to the
right and left
"Off": To concentrate the sound in the center
• Depending on the speaker settings, "Off" is
applied.
p5).
Contents Connections
≫
„ 3. DTS
Change the setting of when DTS signals are input.
Setting Item Default Value
Dialog Control 0 dB
„ 4. Volume
Change the Volume settings.
Setting Item Default Value
Mute Level -∞ dB
Volume Limit Off
Power On Volume Last
Headphone Level 0.0 dB
79
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
You can increase the volume of dialog portion of
the audio up to 6 dB by 1 dB step so that you can
hear the dialog easily in noisy atmosphere.
• This cannot be set for content other than DTS:X.
• Depending on the content, this function may not
be selected.
Setting Details
Set the volume lowered from the listening volume
when muting is on. Select a value from "-∞ dB",
"-40 dB" and "-20 dB".
Set the maximum value to prevent the volume
from becoming too loud. Select a value from "Off",
"-32 dB" to "+17 dB".
Set the volume level of when the power is turned
on. Select a value from "Last" (Volume level before
entering standby mode), "-∞ dB", and "-81.5 dB" to
"+18.0 dB".
• You cannot set a higher value than that of
"Volume Limit".
Adjust the output level of headphones. Select a
value between "-12.0 dB" and "+12.0 dB".
≫