Advertisement
Table of Contents
1 Ton High Lift Professional
2-Stage Transmission Jack
WARNING:
!
Read all instructions and safety warnings before
operating this equipment. Failure to follow the
instructions and safety warnings may result in
personal injury or property damage.
Owner's Manual
PROD. NO. 030537
MOD. NO. 816B
M18_SA030537-ENG-FRE_FA
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Surewerx Strongarm 816B
Summary of Contents for Surewerx Strongarm 816B
- Page 1 PROD. NO. 030537 MOD. NO. 816B 1 Ton High Lift Professional 2-Stage Transmission Jack Owner’s Manual WARNING: Read all instructions and safety warnings before operating this equipment. Failure to follow the instructions and safety warnings may result in personal injury or property damage. M18_SA030537-ENG-FRE_FA...
- Page 2 Round Nut Base (17). At last, tighten the Bolt (20)to the Oil Tank (27) Cross Support Ring (19). Assembling the Saddle (57): First loosen Bolt (S19) and take it out, then put Saddle (57) on the Second Piston Rod (7), and tighten Bolt (S19). surewerx.com...
-
Page 3: Operation
Air Vent Screw (25) and purge away air from hydraulic system as described in Purging Air. Note: Dispose of hydraulic oil in accordance with local regulations. 6. When equipment efficiency drops, purge away air from hydraulic system. 7. It is recommended that an annual inspection be done by qualified technicians. surewerx.com... - Page 4 10. Operate the Pedal (R43) two or three times until there is hydraulic oil (without bubble) overflow from the hole of bleed screw. 11. At the same time, use a 4 mm wrench to tighten M6*8 bleed screw. 12. Press Release Pedal (R40) to make the two pistons retracted. Repeat the above steps again if the pistons are not retracted normally. surewerx.com...
-
Page 5: Troubleshooting Guide
4. Contact with the supplier for repair 1. The release pedal doesn’t work well 1. Check the release pedal for any abnormal Unit fails to keep pressure 2. Inner leaking 2. Contact with the supplier for repair surewerx.com... - Page 6 PARTS surewerx.com...
-
Page 7: Parts List
Washer Bolt Caster with Brake Bolt Washer Lock washer Lock washer Bolt Adjusted support rod Saddle Cotter pin Bolt U-ring Oil tank U-ring Screw Cotter pin First Limited Valve Handle Pump Handle cover Steel Ball Seal ring Spring Screw surewerx.com... - Page 8 PARTS Part No. Description Part No. Description Bolt AdjustedHandle Block Bolt Plate Cover Washer Bolt Saddle Base Chain Hook Plate Carrier Hook Base Washer Pin2 Washer Bear Retainer Ring Washer Pin1 Chain Retainer Ring Bolt Cotter Pin surewerx.com...
- Page 9 Small Pump Core O-Ring Washer Push Rod O-Ring Copper Washer U-Ring Screw Pump Core Base Screw Retainer Ring Screw O-Ring Connector Small Copper Washer Filter Steel Ball First Limited Valve Release Valve Core Pump O-Ring Steel Ball Spring Spring surewerx.com...
Need help?
Do you have a question about the Strongarm 816B and is the answer not in the manual?
Questions and answers