Russell Hobbs RHDH2002 Manual page 11

USING YOUR DEHUMIDIFIER
Setting the Timer
Delayed Start
•
The unit must be switched OFF for the Auto Start function to be
programmed.
•
With the unit switched off, press the Timer button until the Timer
indicator light is illuminated. "0.0" will be displayed on the LED display.
•
Use the up and down control buttons to select the desired delayed
start time.
•
The delayed start time can be adjusted in 0.5 hour increments up to 10
hours, and then in 1 hour increments up to 24 hours.
•
The selected time will stay on the display for 5 seconds, and will then
disappear. The countdown to the start time can be viewed by pressing
the Timer button again.
Auto Stop
•
The Auto Stop function can only be set when the unit is ON.
•
Press the Timer button until the Timer Off indicator is illuminated.
•
Use the up and down controls to select the desired end time.
•
The stop time can be adjusted in 0.5 hour increments up to 10 hours,
and then in 1 hour increments up to 24 hours.
•
The selected time will stay on the display for 5 seconds, and will then
disappear. The Auto Stop time can be viewed by pressing the Timer
button again.
•
Both the Delayed Start and Auto Stop functions can be initiated in the
same sequence. In this instance, both Timer On and Off indicators will
be illuminated.
Note: Turning the unit On or Off at any time will cancel the Delayed Start
or Auto Stop functions and the unit can take 2 minutes to restart.
If the time is adjusted to "0.0" this will also cancel the Timer function.
If the water drawer is full or "P2" is displayed, the Delayed Start and Auto
Stop functions will be cancelled.
Page 11