Sanitaire RSCS280A Owner's Manual page 8

9. When installing the new lamps, carefully examine the pin configuration on the lamps base to ensure that the lamp is installed
correctly into the lamp connector (See Figure 5, which shows the lamp connector and Figure 6, which shows the lamp base,
below).
10. Begin installing the STER-L-RAY
been installed.
11. Hold the STER-L-RAY
12. Once the STER-L-RAY
support. (See Figure 8)
13. Repeat until all STER-L-RAY
rays are harmful to the eyes and skin.
14. Close and lock access door.
15. Restore power to the fixture.
16. Verify operation by viewing Lamp Operation Indicators (LEDs). If the sanitizer is not operating properly, go to
"Troubleshooting" section.
8
Figure 5
lamps from one side and continue to the next until all STER-L-RAY
®
lamp by the base and carefully push the STER-L-RAY
®
lamp is securely seated into the connector, carefully push the STER-L-RAY
®
lamps have been installed into the unit.
®
Avoid exposure to direct or reflected germicidal ultraviolet rays. Germicidal ultraviolet
Figure 7
Figure 6
® lamps have
lamp into the connector. (See Figure 7)
®
® lamp into the end
Figure 8