Page 1
COMPANY SPECIALIZING IN BUILT-IN OVENS AND HOBS HOBS PVA 60 CREAZIONE AUTONOMOUS GLASS-CERAMIC USER’S MANUAL...
Page 2
Installation and Operating Manual Dear Customer! Thank you for purchasing FORNELLI appliance. We hope that this product will meet your expectations and become an excellent assistant in your kitchen. To ensure proper and safe operation of the product, please, carefully read all the provisions of this Manual. Furthermore, please, keep this Manual for the entire service life of the unit.
Maintenance and repairs ...................... 26 The manufacturer reserves the right to make changes to the design of the appliance in order to improve its performance. This product conforms with European standards and has valid CE, TUV, ISO 9001 and EAC conformity certificates. TM FORNELLI...
HOBS Installation and Operating Manual SAFETY INSTRUCTIONS AND ADVISES SAFETY REQUIREMENTS Users of the glass-ceramic hob must know WARNING! and comply with the safety rules on handling To avoid damage of the glass-ceramic consumer electric appliances and carefully hob in the cold season, please, keep the read and understand this Manual.
Page 5
HOBS Installation and Operating Manual cord must be replaced by a service center the glass ceramic hob by yourself. Repairs or similar qualified personnel. performed by unqualified persons can result This hob is intended exclusively for cooking, in equipment damage and accidents. First of it must not be used for heating premises all, refer to these instructions.
HOBS Installation and Operating Manual HOW TO PREVENT DAMAGE Never put pans or frying pans on the hob OF THE HOB frame, this may cause scratches and other damage. Glass ceramics is resistant to drastic tem- perature changes, being a very strong mate- rial in relation to such temperature variations.
HOBS Installation and Operating Manual SCOPE OF DELIVERY STORAGE Store the hob in a dry place, away from Your glass ceramic hob is a built-in kitchen sources of heat and direct sunlight. When appliance. Nameplate containing the model storing an oven, avoid rapid temperature of the hob is attached to the rear side of the changes.
Page 8
HOBS Installation and Operating Manual TECHNICAL SPECIFICATIONS Dimensions of the Hob and the Opening for Building-in of the Hob Dimensions of the Hob’s Depth Height Width Built-in Part, mm (length) Dimensions of the Visible Part Dimensions of the built-in part of the hob 554,4 484,2 Niche dimensions...
HOBS Installation and Operating Manual YOUR NEW GLASS CERAMIC HOB Glass ceramic hob surface Types of burners Front left burner This model has four burners. Three burners are single-circuit ones with permanents heat- Rear left burner ing area size. The fourth one is a twin-circuit Rear right burner burner with variable heating area.
HOBS Installation and Operating Manual CONTROL PANEL Figure 3 1. Burner selector buttons 2. Heating zone extension button 3. Controls lock button 4. Minus button 5. Timer control button 6. Plus button 7. ON/OFF. To start cooking: After the hob is ON, a single audio signal will be sounding, and all indicators will light up for 1 second and then go off, thus indicating, that the ceramic hob is now in a standby mode.
HOBS Installation and Operating Manual 4. Adjust the desired heating power by touching “-“ and “+” but- tons. If you will not set the heating power within 1 minute, the hob will switch off automatically. After You Have Finished Cooking 1.
HOBS Installation and Operating Manual 2. The power level indicator will start blink- 2. Press and hold lock button for a ing. Now press heating extensions but- while. ton. 3. Now you can resume using your hob. WARNING: When the controls are locked, all buttons ex- cept ON/OFF button will be inactive, there- After 5 seconds the indicator will stop blink- ing, and the twin heating function will be ac-...
Page 13
HOBS Installation and Operating Manual – You may elect to set the timer to switch off one or several burners upon expiry of a certain time period. You may set timer on maxi- mum 99 minutes. Using a Countdown Timer When selecting one of the burners, make sure that the hob is OFF.
Page 14
HOBS Installation and Operating Manual 2. Touch the timer button, figure “00” will be displayed in the tim- er display, while figure “0” will be blinking. 3. Set the timer using “+” and “–“ buttons (for example, to “5”). 4. Touch the timer button again; figure “0” will start blinking. 5.
HOBS Installation and Operating Manual 2. Upon expiry of the set time corresponding COOKWARE AND ENERGY burner will be switched off. SAVING Use cookware with solid, strong, flat bot- The minute display will display the next min- toms; the bottom must be as thick, as it is imal set time and the red dot of the corre- practically possible.
HOBS Installation and Operating Manual Use smaller cookware to cook small amounts Don’t forget to switch the burners to the low- of food, and always place this cookware in er heating/power level to exclude spilling of the center of a burner. When cooking in large boiling liquids.
Page 17
HOBS Installation and Operating Manual − Some cooking methods, including cook- Stir-Fry ing of rice with the full water absorption, (Cooking technique in which ingredients are may require a heating level higher than fried in a small amount of very hot oil while the lowest value to ensure cooking of being stirred in a wok) foods properly and at the recommended...
HOBS Installation and Operating Manual Power/Heating Level Suitable for: 1–2 • Warming up small amounts of food, melting chocolate, butter and easily burning foods • Slow boiling at low temperatures • Slow warming up 3–4 • Repeated warming up • Intensive boiling ta low temperatures •...
Page 19
HOBS Installation and Operating Manual What? How? Warning! Stains left by boiled Immediately remove these types Remove stains left by melted and su- out liquids, melted of contamination with a kitchen gar-containing foods, as well as the foods and hot spots scraper or cooking blade suitable for stains left by boiled away liquid as left by burnt sugar...
Page 20
HOBS Installation and Operating Manual TROUBLESHOOTING Bojājums Iespējamie iemesli Rekomendācijas The hob does not switch on No power supply from mains Make sure, that the glass-cera- mic hob is connected to proper source if power supply. Make sure, that there is no power outage in your house and/or neighborhood.
HOBS Installation and Operating Manual INSTALLING INSTALLATION THE GLASS-CERAMIC HOB Cut out an opening with the dimensions, as shown in Figure below, In the countertop, into WARNING! which you are going to install the hob. The hob must be installed by qualified Ensure that along the entire perimeter of the personnel only.
Page 22
HOBS Installation and Operating Manual A – 760 mm B – 50 mm (min) C – 20 mm (min) D – Air input port E – Air output port 5 mm Before proceeding with the installation of The input switch must be of approved type the hob, please, make sure that: and ensure at least 3 mm gap between open contacts on each AC phase (or on each acti-...
HOBS Installation and Operating Manual • in the event that the hob is installed WARNING above a kitchen cabinet, there is a 1. The hob must be installed by qualified thermal insulation installed between personnel only! Contact professional the hob bottom and the cabinet; service companies, don’t try to install the •...
Page 24
HOBS Installation and Operating Manual Don’t use any adapters, splitters or extension – In the event that any cables are damaged cables to connect the hob to electric mains, or need to be replaced, all the operations because they are capable of facilitating over- must be carried out by a post-sale servi- heating and may cause fire.
It is strongly recommended to contact the nearest FORNELLI service center or the shop where you bought the product. If your product is still covered by the manufacturer’s warranty, then while calling...
Page 27
Warranty service conditions The products are subject to free repair, if used only agency and signature of a sales assistant (inclu- for personal, family or other needs, not related to ding a tear-off card), model and the serial number business activities, or satisfying household requi- of the product.
Page 28
Warranty service conditions Installation and Operating Manual – installation regulations have been violated, as – mechanical damage to the product (scratches, stated in the product manual; cracks, spalls, etc.); – the product has not been timely serviced and – loss of the saleable condition due to impact of maintained, as the product manual requires;...
Need help?
Do you have a question about the PVA 60 CREAZIONE and is the answer not in the manual?
Questions and answers