Sea Quest Pro QDi3 Owner's Manual page 12

6. Place the fitting over the quick dis-
connect plug and firmly push inward
while releasing the hose grip. Check to
ensure the hose is securely attached.
7. To test the connection, slowly open the cylinder valve
and pressurize the regulator. Lift up on the lever and listen
for the flow of air into the BC bladder.
NOTE: The Pro QDi3 is equipped with a longer than normal MP in-
flator hose. It is very important to use the inflator hose provided with
the BC (if the hose is too short it will not reach the i3 control unit.
Hose lengths are as follows:
XS/S – 27 inches (pn 24827 — red)
M/ML/L – 33 inches (pn 24833 — light blue)
XL – 36 inches (pn 24836 — blue)
XXL – 40 inches (pn 24840 — light gray)
Pro QDi3 BC Owner's Manual