Lcd Display - Electro-Voice RE3 Series Installation Manual

en | RE3-HHT handheld transmitter
38
14 ▲ up button
Display and control
15
section - Rear
16 Sync signal port
8.2

LCD display

ID Item
a
RF power icon
b
Frequency in MHz
c
AutoOff icon
d Mute
e
Frequency in kHz
f
Battery status icon
2018-12 | 01 | F.01U.362.808
This menu navigation button adjusts the value of an editable
parameter. Pressing the ▲ button will increase the displayed value of
the current parameter, or the next state condition value above the
displayed state value.
The side opposite of the LCD display and the sliding navigation button
cover
When syncing the transmitter to the receiver, aim the transmitter's
unobstructed sync port directly toward the receiver's sync emitter. A
direct line of sight is required. Maintain a distance between two inches
and twelve inches (or between 5cm and 30cm) for best sync
performance. The LED indicator (#10) flashes blue during the sync
operation and glows solid blue for three seconds when sync operation
is successful. The LED return to green after syncing.
Description, usage and notes
The RF power indicator is always visible.
indicates RF power is set to low.
indicates RF power is set to high (band specific).
The portion of the tuned frequency to the left of the decimal in millions
when the transmitter home screen is set to Freq.
The display shows this icon when auto off is engaged. It begins
flashing when the transmitter is muted indicating the countdown to
shutoff has begun.
The display shows MUTE only when the transmitter is muted.
The portion of the tuned frequency to the right of the decimal in
thousands when the transmitter home screen is set to Freq.
Indicates battery life.
= between 40% and 100% charge remains.
= between 20% and 39% charge remains.
= between 10% and 19% charge remains.
= below 10% charge remains.
BATTLo appears on the display and the empty cell icon begins flashing
when batteries are nearing empty.
Installation manual
RE3 UHF Wireless
Electro-Voice