Defining A Talk Group For Data Use - Kenwood TK-780 Programming Instructions Manual

Defining a Talk Group for Data Use

There are two places in the system information screen that you have to define a talk
group as being a data talk group.
First, select the data talk group with your cursor, and press the F9 Key. This will bring
up the System Data screen as shown in the figure below. Program the Data
System/Group for the system and group number in your radio. This value will vary
based on how many systems and groups are programmed into your radio.
Program the
appropriate
System/Group for
the data group
Second, you must define the talk group as data in the group information screen. To
access the group information screen, select the data talk group with your cursor and press
the F10 key. The figure below shows how to define the talk group as data.
Set Data to Yes
+------------------------------------- +
¦ System Data
¦------------------------------------- ¦
¦ System Name
¦ System Lockout
¦ Scan Weight
¦ Auto TEL Search
¦ TA Busy Ch LOut
¦ Wide/Narrow
¦ Fix ID
¦ ID
¦ Call Indicator
¦ Horn Alert
¦ Opt Signalling
¦ Block ID's
¦ Telephone
¦ TX Inhibit
¦ Decode
¦ Data System/Group
¦ Data Delay Time
+------------------------------------- +
+---------------------------------- +
¦ Group Data 2
¦---------------------------------- ¦
¦ Encode ID
¦ Decode ID
¦ Group Name
¦ TX Power
¦ Call Indicator
¦ Horn Alert
¦ Option Signalling : [None]
¦ Group-Lockout
¦ Transpond
¦ Talk Around
¦ Compander
¦ Home Group
¦ PTT ID
¦ Data
+---------------------------------- +
¦
: [ 1 ] ¦
: [***] ¦
: [*] ¦
: [N o ] ¦
: [No ] ¦
: [******] ¦
1st 2nd ¦
: [ ] [ ] ¦
: [***] [***] ¦
: [***] [***] ¦
: [****] [****] ¦
Start Stop ¦
: [ - ] ¦
: [ - ] ¦
: [ - ] ¦
: [ 1 - 2 ] ¦
: [ 15]ms ¦
¦
: [151] ¦
: [151] ¦
: [Data Chan ] ¦
: [****] ¦
: [No ] ¦
: [No ] ¦
¦
: [No ] ¦
: [No ] ¦
: [No ] ¦
: [***] ¦
: [***] ¦
: [Off] ¦
: [Yes] ¦
6