EGO CTA9500 Operator's Manual page 25

To Adjust
When tilling in a confined area or between
rows, the cultivator may be used with only
the inner blades installed.
Wear gloves and remove the two hitch
pins to remove the two outer blades
(Fig. 11), and then insert the hitch pins
into the locking hole-2 (Fig.12 & 13).
NOTICE:
Do not force the blades on
or off the drive shaft. If you experience
difficulty when removing the blades, apply
some penetrating oil on the shaft. When
reinstalling the blades, make sure to clean
and oil the drive shaft and the blades.
CLEAN THE UNIT
Parts of plants, such as roots, can become
tightly wrapped around or between the
rotating blades during operating. To clean
the rotating blades:
◾
Remove the battery.
◾
Wear gloves. Clean the pieces of
roots, clogged soils or plants on
the blade, guard or the gear box.
For thorough cleaning, remove the
blades and guard to wash them
thoroughly. For detailed replacement
steps please see above section
"REPLACING OR ADJUSTING THE BLADES".
◾
Wipe the tool surface with a clean cloth moistened with a mild soap solution.
Keep the air vents free of obstructions.
CULTIVATOR ATTACHMENT — CTA9500/CTA9500-FC
11
12
13
Locking Hole-1
Locking Hole-2
25