Advertisement
2
Set the surface-mount bracket aside.
Do not drill through the bracket.
3
Drill the three 3.2 mm (
3
4
Drill the 19 mm (
/
in.) cable hole in the center.
4
5
Use the included M4 screws to secure the surface-mount
bracket to the mounting surface.
6
Route the cable
through the center hole and connect it to
the antenna.
7
Verify the large gasket
antenna, place the antenna on the surface-mount bracket,
and twist it clockwise to lock it in place.
8
Secure the antenna to the mounting bracket with the included
M3 screw
.
9
Route the cable away from sources of electronic interference.
Mounting the Antenna with the Cable Routed Through
the Pole
Before you permanently mount the antenna, you must test the
mounting location for correct operation
Considerations, page
1).
1
Position a standard 1 in. OD, 14 threads per inch, pipe-
threaded pole (not included) in the selected location, and
mark the approximate center of the pole.
2
Drill a hole using a 19 mm (
pass through.
3
Fasten the pole to the boat.
4
Thread the pole-mount adapter onto the pole.
Do not overtighten the adapter.
5
Route the cable through the pole and connect it to the
antenna.
6
Place the antenna on the pole-mount adapter and twist it
clockwise to lock it in place.
7
Secure the antenna to the adapter with the included M3 set
screw
.
2
1
/
in.) pilot holes.
8
is in place on the bottom of the
(Antenna Mounting
3
/
in.) drill bit for the cable to
4
8
With the antenna installed on the pole mount, fill the vertical
cable slot
with a marine sealant (optional).
9
Route the cable away from sources of electronic interference.
Mounting the Antenna with the Cable Routed Outside
the Pole
Before you permanently mount the antenna, you must test the
mounting location for correct operation
Considerations, page
1).
1
Route the cable through the pole-mount adapter
place the cable in the vertical slot
pole-mount adapter.
2
Screw the pole-mount adapter onto a standard 1 in. OD, 14
threads per inch, pipe-threaded pole (not included).
Do not overtighten the adapter on the pole.
3
Connect the cable to the antenna.
4
Place the antenna on the pole-mount adapter and twist it
clockwise to lock it in place.
5
Secure the antenna to the adapter with the included M3 set
screw
.
6
With the antenna installed on the pole mount, fill the
remaining gap in the vertical cable slot with a marine sealant
(optional).
7
Attach the pole to the boat if it is not already attached.
8
Route the cable away from sources of electronic interference.
Connection Considerations
If you are connecting the audio cable from the wiring harness,
you must connect it to the line-in or auxiliary port on a stereo.
Attempting to connect the audio cable directly to a speaker will
result in poor performance, and it may cause the antenna to
shut down, which might damage the antenna or the speaker.
You must connect this antenna to power and to the Garmin
Marine Network to provide weather information to connected,
compatible Garmin devices.
(Antenna Mounting
, and
along the base of the
NOTICE
Advertisement
