Adjusting The Feet; Electrical Connection - Beko WTV 7502 B0 User Manual

Installation
• To prevent flowing of dirty water back into the
machine and to allow for easy discharge, do not
immerse the hose end into the dirty water or do
not drive it in the drain more than 15 cm. If it is
too long, cut it short.
• The end of the hose should not be bent, it
should not be stepped on and the hose must not
be pinched between the drain and the machine.
• If the length of the hose is too short, use it by
adding an original extension hose. Length of the
hose may not be longer than 3.2 m. To avoid
water leak failures, the connection between
the extension hose and the drain hose of the
product must be fitted well with an appropriate
clamp as not to come off and leak.

3.6 Adjusting the feet

A
WARNING:
the product operates more silently and
vibration-free, it must stand level and
balanced on its feet. Balance the machine
by adjusting the feet. Otherwise, the
product may move from its place and
cause crushing and vibration problems.
1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the product stands level and
balanced.
52 / EN
In order to ensure that
3. Tighten all lock nuts again by hand.
A
WARNING:
loosen the lock nuts. Otherwise, they will
get damaged.

3.7 Electrical connection

Connect the product to a grounded outlet
protected by a 16 A fuse. Our company shall not
be liable for any damages that will arise when the
product is used without grounding in accordance
with the local regulations.
• Connection must comply with national
regulations.
• Power cable plug must be within easy reach
after installation.
• If the current value of the fuse or breaker in the
house is less than 16 Amps, have a qualified
electrician install a 16 Amp fuse.
• The voltage specified in the "Technical
specifications" section must be equal to your
mains voltage.
• Do not make connections via extension cables
or multi-plugs.
B
WARNING:
must be replaced by the Authorized
Service Agents.
Transportation of the product
1. Unplug the product before transporting it.
2. Remove water drain and water supply
connections.
3. Drain all water that has remained in the product.
See 6.5
4. Install transportation safety bolts in the reverse
order of removal procedure; see 3.3.
C
Never move the product without the
transportation safety bolts properly fixed
in place!
A
WARNING:
dangerous to children. Keep packaging
materials in a safe place away from reach
of the children.
Do not use any tools to
Damaged power cables
Packaging materials are
Washing Machine / User's Manual