Action In The Event Of A Malfunction; Disposal; Safety Label - Neo Pro PTA07 Customer Product Manual

Action in the Event of a Malfunction

If a system or any equipment in a system malfunctions, shut off the system
immediately and perform the following steps:
_
Disconnect and lock out electrical power. Close pneumatic shutoff
valves and relieve pressures.
_
Identify the reason for the malfunction and correct it before restarting the
equipment.

Disposal

Dispose of equipment and materials used in operation and servicing
according to local codes.
1-4
Safety
Safety Labels
Table 1-1 contains the text of the safety label on this equipment. The safety
label is provided to help you operate and maintain your equipment safely.
Table 1-1 Safety Label Shipped With Powder Spray Guns
WARNING: The following procedures MUST be followed when working with
this electrostatic spray equipment. Failure to follow these instructions may
result in a fire and/or serious personal injury. Display this warning on the
spray booth.
1. NO SMOKING. Keep open flames, hot surfaces, and sparks from torches
or grinding away from booth.
2. Turn the electrostatic power unit off when the spray gun is not in use.
3. Shut down immediately in event of fire.
4. Maintain ground circuit on all conductive objects below 1 meg ohm to
prevent sparking.
5. Shut down operation and correct grounds if sparking occurs.
6. Install fixed fire suppression system before operating with combustible powder.
7. Install automatic flame detectors before operating automatic guns.
8. Examine all equipment at the beginning of each work period and repair or
replace any damaged, loose, or missing parts.
9. Before cleaning or performing any maintenance on the electrostatic spray
gun, turn off the power unit and ground the nozzle. Maintain electrostatic
spray equipment in accordance with instruction manual. Do not deviate.
Do not substitute parts from other manufacturers.
10. Operator must be grounded to prevent shocks from static electricity.
Floor surface must be conductive. Footwear and gloves must be static
Dissipative.
11. Air velocity through all booth openings must meet local requirements and
contain powder within the booth. If powder escapes from the booth, shut
down operation and correct the malfunction.
12. Powder may be toxic or be a nuisance dust hazard. Refer to supplier.s
MSDS. If exposed to dust during operation, maintenance, or clean up,
operators must use appropriate personal protective equipment.
13. Do not use compressed air or organic solvents for removal of powder
from skin or clothing. Do use soap and water. Wash hands before eating
or smoking.
14. Guns, feeders, booths, etc., may be cleaned with clean dry air at 1.7 bar
(25 psig). If you have any questions concerning this electrostatic spray equipment, call
+90 216 362 10 34, and ask to speak with the Powder Systems Group Technical Service Department.