Camera Menu - Cobra Elite Road Scout Owner's Manual

Camera Menu

Recording
Turns off and on recording (factory default is on).
Microphone
Turns off and on the microphone for audio recording
(factory default is on).
Loop Clip Time
Sets the duration of movie clips. Clips can be set in 1,
3, or 5 minute lengths (factory default is 3 minutes).
G-Sensor
Road Scout includes a built in G-Sensor which allows
the device to determine when the car has been in a
collision. If a collision is detected, Road Scout
automatically locks the recording being made at the
time of the accident. You can use this setting to set
the sensitivity of the G-Sensor from 1-3 or turn it off.
Level 1 is the easiest to activate and may lock files
due to smaller bumps causing the SD card to fill up
quickly with protected files. Level 3 is the hardest to
activate the G-sensor (factory default is Level 2).
Cobra Watermark
Turn off or on placing a Cobra watermark on saved
movie clips (factory default is on).
Date/Time Stamp
Turn off and on placing a date and time stamp on
movie clips (factory default is on).
Restore Camera Default
Press MARK to restore all Camera Menu settings to
factory defaults.
Format SD Card
Press MARK to format the SD card.
Importantly, be aware that this will erase all content on
the SD card including locked SOS movie clips.
Setup Camera
Press MARK to enter the Camera Setup menu, then
repeatedly press MARK to cycle through all of the
camera setup options.
- Select the correct Time Zone for your location.
- Select Standard Time or Daylight Saving Time.
- Aim Camera. Use the Rotary Dial to display the
camera's footage on the screen to properly aim
the camera.
13