Power Sources - Sony TU-1041U Operating Instructions Manual

Power Sources

House Current
Connect the AC power cord (supplied) to the AC IN socket
and to a wall outlet.
EJECT
BATTERY
to AC IN
to a wall outlet
To connect an AC power cord securely with an AC plug holder
1
AC power plug
Plug the power cord into the AC IN socket. Then, attach the
AC plug holder (supplied) on top of the AC power cord.
To remove the AC power cord
Pull out the AC plug holder by squeezing the left and right
sides.
Rechargeable Battery
The tuner can operate with the NP-1B battery pack (not
supplied).
SONY mark downwards
NP-1B
(not supplied)
DC 12V IN jack
Connect DC 12V power source to the DC 12V IN jack.
Use AC-550 AC adaptor (not supplied) to connect this jack
to a wall outlet.
AC IN
VHF/UHF
L R
VIDEO AUDIO
LINE OUT
CONTROL S
IN OUT
AC plug
holder
VH F/ UH F
R
L
AU DI O
VI DE O T
LI NE OU
L S
CO NT RO
OU T
IN
VI DE O
L
R
AU DI O
LI N E O
U T
CO NT RO
IN L S
O UT
EJECT button
When the AC power cord is plugged into the AC IN socket,
the battery pack (if installed) will automatically be
disconnected.
2
Slide the AC plug holder over the cord until it connects
with the attached holder.
To conserve the battery
While pressing the MEMORY button, press the 2 button.
The channel number on the program indicator disappears
and the tuner goes into the energy saving mode.
To return to the normal mode, repeat the same procedure.
Notes
• Make sure that the AC power cord is disconnected from
the tuner. Otherwise, the tuner cannot operate on the
battery pack.
• The tuner can not charge the battery. For charging, use the
battery charger (not supplied).
VH F/ UH F
R
L
AU DI O
VI DE O T
LI NE OU
L S
CO NT RO
OU T
IN
7