Causes For Damages; Protecting The Environment; Operating Modes; Exhaust Air Mode - Bosch HCP30651UC Use And Care Manual

Causes for damages

CAUTION
9
Risk of damage due to corrosion. Always turn
appliance on when cooking to avoid condensation
buildup. Condensation can lead to corrosion
damages.
Always replace burnt out bulbs immediately to avoid an
overload of the remaining bulbs.

Protecting the environment

Unpack the appliance and dispose of the packaging in
line with environmental requirements.

Operating modes

You can use this appliance in the air extraction or the
recirculation mode.

Exhaust air mode

The air that is drawn in is cleaned by
the grease filters and conveyed to the
exterior by a pipe system.
Note: Ventilation may not exit through an already
operational smoke or exhaust chimney, nor a duct used
for ventilating furnace installation areas.
If the ventilation is intended to pass through a smoke
or exhaust chimney that is not in operation, the
responsible area heating inspector must give approval.
If the ventilation passes through an external wall, use a
telescoping wall sleeve.
6
Risk of damage due to the presence of humidity in the
electronic circuitry. Never clean operator controls with a
wet cloth.
Surface damage due to incorrect cleaning. Clean
stainless steel surfaces in the grain direction only. Do not
use any stainless steel cleaners for operator controls.
Surface damage due to strong or abrasive cleaning
agents. Never use strong and abrasive cleaning agents.
Risk of damage from condensation back flow. Install
exhaust vent at a slight downward slope away from the
appliance (1° slope).
Re-Circulating air mode
The air that is drawn in is cleaned by the
grease filters and an activated carbon filter
and conveyed back into the kitchen.
Note: To capture odors in re-circulating air mode, you
must install the recirculating air kit with an activated
carbon filter. The different options for operating the
appliance in re-circulating air mode can be found in the
User Manual.
Alternatively, ask your dealer. The required accessories
are available for purchase from specialist retailers,
from customer service or from the Online Shop.
The accessory numbers can be found at the end of the
instructions for use.