Maintenance And Cleaning - Homematic IP HmIP-SPI Mounting Instruction And Operating Manual

Maintenance and cleaning

To restore the factory settings of the presence sensor,
please proceed as follows:
• Rotate the device anti-clockwise in order to re-
move it from the mounting plate (see figure 7).
• Remove a battery.
• Insert the battery ensuring that the polarity is cor-
rect and press and hold down the system button
(B) for 4 seconds at the same time, until the LED
will quickly start flashing orange (see figure 6).
• Release the system button again.
• Press and hold down the system button again for
4 seconds, until the status LED lights up green.
• Release the system button to finish the procedure.
The device will perform a restart.
11 Maintenance and cleaning
The device does not require you to carry out any
maintenance other than replacing the battery
when necessary. Enlist the help of an expert to
carry out any maintenance or repairs.
Clean the device using a soft, lint-free cloth that is clean
and dry. You may dampen the cloth a little with lukewarm
water in order to remove more stubborn marks. Do not
use any detergents containing solvents, as they could
corrode the plastic housing and label.
38