Table of Contents
Advertisement
Installation Continued
Leveling feet
ELECTRICAL CONNECTION
• WARNING! It must be possible to disconnect the appliance from the mains power supply;
the plug must therefore be easily accessible after installation.
• Before plugging in your new bar fridge, let it stand upright for at least 2 hours. This will allow the
refrigerant gases to settle into the compressor and reduce the possibility of a malfunction in the
cooling system.
• The appliance must be earthed. The plug of the power supply cord is equipped with a contact
for this purpose. Do not under any circumstances cut or remove the third (earth) prong from the
power cord.
If the plug does not fit your outlet, consult a licensed electrician for advice to have the outlet
changed.
• Plug the unit into a dedicated, properly earthed wall outlet. Ensure that your outlet voltage and
circuit frequency correspond to the voltage stated on the rating label.
• Secure the bar fridge's supply cord behind the unit. Do not leave it exposed or dangling to
prevent injury and accidental disconnection from the power supply.
• Adjust the temperature control as described below.
• When first starting up, and after a period out of use, allow the unit to cool down for at least 2–3
hours (4 hours if starting up during warm weather in summer) before placing food in the bar
fridge.
SCHEMATIC DIAGRAM OF THE LEVELING FEET
The picture above is only for reference. The actual configuration will depend on the physical
product or statement by the distributor
Adjusting procedures:
a. Turn the feet clockwise to raise the refrigerator;
b. Turn the feet counterclockwise to lower the refrigerator;
c. Adjust the right and left feet based on the procedures above to a horizontal level.
9
Advertisement
Table of Contents
