Advertisement
LCD Digital Display Screen & Control
Power Button: Power the unit ON and OFF
Mode Button: Choose between the four operation modes:
1.ALL METAL: The detector will respond to all kinds of metals.
2. DISCRIM: Choose the type of "elimination" metals with the "+" and "-" buttons.
Use this mode along with the 'ELIM' button to disregard metal detection for selected metals.
3. JEWELRY: Eliminates iron targets automatically, and respond to all other metals.
4. CUSTOM: detects a metal, and then only indicates or responds when that similar metal is found
Use the 'DISCRIM' "+ " or " - " buttons and the LCD display will indicate the type of metal you want
to eliminate. Then press the "ELIM" button, and that metal selection will be disregarded from your
metal detection. (Pressing the "ELIM" button again, on the disregarded metal target, will re-establish
detection for that metal.
5. COINS: Used specifically for coin detection (eliminates the iron, pull-tabs, trash metals, etc.)
Sensitivity 'Sens' Button: Choose between the 8 levels of sensitivity with SENS " + " or " - " buttons. Boot
setting remain in the third level setting. The highest sensitivity is the fifth level -- and the first as the lowest.
When you encounter signal interference, you can set the sensitivity lower accordingly.
Pinpoint Button: Press and hold the "PINPOINT" button and the detector converts into the non-motion
mode ,and it no longer has discrimination ability, but has the highest sensitivity. At this time, the
PINPOINT cursor is lit on the LCD display screen. At the same time, the Target ID cursor is rendered
useless, and the lower cursor Target Discrimination cursor turns into the signal strength indication cursor.
The more closer to the metal target, the higher the strength cursor will indicate. Audible warnings will also
sound louder and louder with the strength cursor gaining strength.
Press the PINPOINT button on the handle, and the PINPOINT cursor will appear on the digital display.
The metal detector will now be in the 'Non-Motion' mode, you should be able to locate and pinpoint the
metal target beneath the search coil.
*When detecting objects with the PINPOINT Mode, the closer your search coil center comes to the object,
and the closer in distance between the center of the search coil and the sought-after object, the louder
audible frequency tone will be heard from the metal detector's speakers.
www.PyleAudio.com
Advertisement
