1. Manuals
  2. Brands
  3. Spinshot Manuals
  4. Accessories
  5. SPINSHOT plus
  6. User manual

Spinshot Plus User Manual

Tennis ball machine
Hide thumbs Also See for Plus:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Owner's Manual
SPINSHOT plus
USER MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Plus and is the answer not in the manual?

Questions and answers

Related Manuals for Spinshot Plus

Summary of Contents for Spinshot Plus

  • Page 1 SPINSHOT plus USER MANUAL...

  • Page 3: Section-1: Before Using Machine

    Section-1: Before Using Machine Introduction Thank you for purchasing a SPINSHOT tennis ball machine. This manual contains important information concerning the proper use and care of your ball machine. Please read owner’s manual completely before operating your machine. Tennis Balls To Be Used Please take note that brand new tennis balls are not recommended to be used especially during first ten hours of break-in period.

  • Page 4: Section-2: Operating Machine

    “Maintenance and Cleaning” will restore roper performance. CHARGER JACK Plug the charger into the jack and t he other end into power outlet to start the charging of your machine. REMOTE JACK: It is reserved port but not used for Plus model. Befor...
  • Page 5 First time when use remote, it need to be paired with password of 1234. User can download the install ation code from ttp://www.spinshot.co.uk/Android-Remote.html anual Setting Buttons PLAY/STOP: The button will trigger the machine to start or stop. Every time when you press this button to start the machine, the machine will hold for 10 seconds before it prope l the balls.
  • Page 6 FEED: The FEED button needs to be pressed first when the user adjusts the ball feed interval. Then the user can press the UP or DOWN buttons to adjust the feed rate. Its level is shown on LCD with 9 bei fastest (approximately 1 ba ll every 1 second at the manual setting ode without oscillation).
  • Page 7 2-Line oscillation mode (2-line oscillation or 2-line ertical oscillation). scillation Mode Setting and Buttons SPINSHOT-Plus model can support different oscillation modes, or a ombination of oscillation modes. Overall it can support 5 types of oscillation:  Type-1: RANDOM HORIZONTAL OSCILLATION ...
  • Page 8 forehand and backhand shots. 2-line width can be defined by w1-w2 etting as described in section of “w1-w2”. After the machine has been set to the 2-line oscillation mode, the user can still press vertical oscillation to make the m achine set to a 2-LINE ORIZONTAL AND VERTICAL OSCILLATION.
  • Page 9 3. Each time when the user presses the oscillation button to enter a different oscillation mode, there will be a default setting shown in the LCD. Such a setting is the pre ferred value for the corresponding oscillation mode. 4. Keep pressing the “+” or “-“ butt on will continuously increase or decrease the selected values.

  • Page 10: Static Electricity

    Transporting and Storage Remove all balls and close the ball hopper before transporting your SPINSHOT ball machine. Store the machine in a clean, dry loca tion. Never store the machine in a closed trunk where temperatures can very high.
  • Page 11 wheels through the ball ejection opening to remove the dirt and ink uild-up. Sand the entire circumference of each wheel and use enough pressure to rough-up the rubber surface of the wheels. To clean the case, use a slightly damp cloth. Do not use chem icals or abrasive cleanse rs.

  • Page 12: Section-3: Warranty

    Section-3: Warranty Warranty Period The warranty service is free for materials and workmanship for a period of one year from date of original purchase except for the battery, which is warranted for three months. Scope of Warranty This warranty covers all defects in material and workmanship. The following are not covered by the warranty: ...

Table of Contents