Advertisement
Quick Links
SA502
Install Instructions For:
SA502
Box Contents
1- Amplifier (Input Voltage 30-32VDC)
(UL 60065 compliant)
1- Stereo RCA to mini adapter
1- Power adaptor: Input 100VAC-240VAC, 50/60 Hz
Output 30-32VDC, 3.75A
2- Four-pin Euroblock connectors
3- Three-pin Euroblock connectors
1- Mounting bracket
Faceplate
Faceplate screws (4)
Three-pin Euroblock (3)
Warning
SoundTube products must be installed by a professional audio installer/contractor. For safety
and for optimum audio performance, installer must follow all directions issued by SoundTube.
SA502 amplifier
Four-pin Euroblock
Front
Four-pin Euroblock
1.435.647.9555
© 2012 SoundTube Entertainment, Inc. All rights reserved. PN INS-SA502 Rev01.27.12
Avis
Les produits SoundTube doit être installé par un installateur professionnel audio/contractuer.
Pour plus de sûreté et pour des performances audio optimales, l'installateur doit suivre toutes
les instructions émises par SoundTube.
Six-pin jumper block
Two-pin jumper block
Mounting bracket
Rear
|
|
800.647.TUBE
www.soundtube.com
Three-pin
Euroblock (3)
Advertisement
Related Manuals for SoundTube SA502
Summary of Contents for SoundTube SA502
- Page 1 SoundTube products must be installed by a professional audio installer/contractor. For safety Pour plus de sûreté et pour des performances audio optimales, l'installateur doit suivre toutes and for optimum audio performance, installer must follow all directions issued by SoundTube. les instructions émises par SoundTube.
- Page 2 9. Connect speaker 7c. In bridged mode, the 8a. Stereo and Mono: 8b. Bridged: connect single Euroblock to the SA502. amp becomes a mono block connect speaker wires to 4 pair of speaker wire to the amp with just one input pin Euroblock.
- Page 3 Euroblock, or high external 12v-32v DC on the front of the SA502. wired Euroblock connector, level Euroblock on the front of trigger. To enable, move or via barrel connector with the unit.
-
Page 4: Fcc Notice
SA502 Install Instructions For: SA502 FCC Notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the SA502 and is the answer not in the manual?
Questions and answers