Table of Contents
Advertisement
Bante821 Portable Dissolved Oxygen Meter
Connecting the Sensor
Insert the 6-pin connector of the dissolved oxygen probe into the corresponding connector socket on meter. Ensure the connector is fully seated. After
connection is completed, DO NOT pull on the sensor cord. Always make sure that the connector is clean and dry.
Switching the Meter On and Off
•
Press the
key to switch on the meter, the display shows the measured value.
Meas
•
Press and hold the
Meas
To enable the Auto-Power Off feature, please refer to chapter SETUP MENU.
Prior to Use
•
Remove the protective cap from the bottom of the probe.
•
Switch on the meter 10 to 15 minutes and wait for the probe to polarize.
key for 5 seconds, the meter will switch off.
5
Advertisement
Table of Contents
