Advertisement
Using your Pressurized Garment Steamer
1: Filling with water, unscrew the safety cap from unit, and reference figure 8 for filling cool
water into the boiler.
Caution: 1: Before filling, be sure the boiler has no water. Also, you must mind the boiler
capacity, which is 1500ml (3 measuring cups). Otherwise, hot water will jet out from the
Iron head at the beginning of the unit turning on.
2: Be sure to fill this machine with water only; don't add any other liquids.
NOTE: To prolong the lifetime of your steamer, we recommend using distilled or
de-mineralized water.
2: Screw the safety cap back on as figure 9 shows. Be sure the cap is screwed on tightly onto
the boiler; otherwise there will be steam leakage from there.
3: Plug the unit into a properly grounded three-pronged outlet. Make sure the electric voltage is
the same as the unit spec required.
4: Turn the On/Off Switch to "On." When the switch is illuminated, pre-heat it for 2 minutes and
the steam will be ready.
.
CAUTION: Do not let the steamer operate with a dry boiler, or boiler damage may
occur.
Pressing With Steam
1. Place garment on clothes hanger, and place the hanger on the Clothes Hanger Hook,
steam the garment.
CAUTION: Before steam, please make sure the material of the clothes, and set
temperature accordingly, references the figure 11.
Temperature setting: Dial the knob to the clothes material being steamed to align with the
black dot. Turning in the clockwise direction will raise the temperature; counterclockwise
direction will lower the temperature.
Try iron: After the temperature is set and the nozzle's light is off, we're ready to iron.
We recommend that you first test the iron on the inside of your clothes to examine if the
temperature is too high or not. If the temperature is too high, it may burn the clothes.
CAUTION: During the temperature setting, don't press the steam button. Otherwise,
the steam may escape from the nozzle and burn you.
2. Grasp the Steam Nozzle Handle, and place the Steam iron head on the garment. Press the
steam button; the pressurized Steam will come out from the soleplate of Steam iron head,
Slide the iron head from the bottom to the top of the garment until you remove all of the
wrinkles and refresh the clothes. You can also iron your coat on the ironing board with the
Steam Iron head following 2 steps: a) put your coat on the ironing board, b) slowly move the
Steam Iron head on the coat, instantly remove the wrinkle. Shown in figure
13.
Advertisement
