Related Manuals for OJ Electronics OJ Drives OJ-DV-HMI-35T
Summary of Contents for OJ Electronics OJ Drives OJ-DV-HMI-35T
- Page 1 QUICK START GUIDE OJ-DV-HMI-35T OJ Drives ® A DRIVES PROGRAMME DEDICATED TO VENTILATION SOLUTIONS...
- Page 2 GND, the OJ-DV-HMI-35T will automatically switch from a “passive” to “active” controller of the OJ-DV. If the Modbus communication is reestablished to ports “A”, “B” or the spring terminals A, B and GND, the OJ-DV-HMI-35T will automatically switch back from an “active” to a “passive” controller. © 2019 OJ Electronics A/S...
- Page 3 Readout of software version Note that a PIN code is required to change the settings in the “Configuration” menu and thus alter the configuration of the drive. Contact OJ Electronics to obtain this PIN code. Setpoint This screen is used to change the different values and to enter a password. Use the displayed numeric keypad to select the value and press OK to confirm the new value.
- Page 4 The DV will search for the default Modbus address for 10 seconds before changing and searching for the alternate Modbus address. Protective cover The OJ-DV-HMI-35T is supplied with a silicon protective cover to protect it against knocks, oil and dirt. © 2019 OJ Electronics A/S...
- Page 5 3.5 mm and a length that is not longer than 9 mm. Fitting onto a flat metal surface using magnets The black protective cover contains two magnets. The HMI can be fitted onto a vertical flat metal surface using the bumper cover (see Fig. 1.1). © 2019 OJ Electronics A/S...
-
Page 6: Technical Data
All trademarks in this material are the property of the respective companies. OJ and the OJ logotype are trademarks of OJ Electronics A/S. All rights reserved. CE marking OJ Electronics A/S hereby declares under sole responsibility that the product complies with the following EU Directives: EMC – Electromagnetic compatibility: 2014/35/EU RoHS –...
Need help?
Do you have a question about the OJ Drives OJ-DV-HMI-35T and is the answer not in the manual?
Questions and answers