Table of Contents
Advertisement
Commonfault
The socket is
The robot
doesn't work
Connection is wrong
Impeller is
jammed or dirty
Weak pumping
Impeller is damage
Filter cartridge is full
Drive Belt is loosen
or broken at one side
Robot is turning
to one side when it
Filter cartridge is full
moves
Broken Coupling block
Drive Belt is
loosen or broken
Robot will not
climbs wall
Pool Cleaner
will not sink to the
bottom of the pool
Dirt is coming
through the
guide vane.
Note: The Power Box MUST BE DISCONNECTED from the power supply prior to
conducting any maintenance on the Robot. Contact your local distributor, or place of
purchase for problems not covered in Trouble Shooting Guide.
HANGZHOU GAOYUE TECHNOLOGY CO., LTD.
Reason
not plugged in
Filter cartridge is full
Sponge wheel wear
Axis sleeves wear
The sponge wheel
don't soak enough
It has air inside
the machine
Filter Cartridge is
loosen or broken.
Dirt is too fine for
the filter Cartridge
-16-
Solution
Plug in the power lead
Check the connection
Clean the Impeller
Replace the Impeller
Clean the Filter cartridge
Replace the Drive Belt
Clean the Filter cartridge
Replace Coupling block
Clean the Filter cartridge
Replace the Drive Belt
Replace the Sponge wheel
Replace axis sleeves
You must hold cleaner
in water and make sure
sponge wheel soak enough,
normal time is about 5-15
minutes
Wobble iCleaner-300 and
make sure air released
Replace the broken
Filter Cartridge
Purchase a finer grade of
Filter cartridge if available.
Remarks
Please turn off the
power before you
perform any
maintance on the
pool cleaner
Advertisement
Table of Contents
