Multiple Vrrp Standby Group Configuration Example - H3C S5500-EI Series Operation Manual

Operation Manual – VRRP
H3C S5500-EI Series Ethernet Switches
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
The above information indicates that if VLAN-interface 3 on Switch A is not available,
the priority of Switch A reduces to 80 and it becomes the backup. Switch B becomes the
master and packets sent from Host A to Host B are forwarded by Switch B.

1.5.3 Multiple VRRP Standby Group Configuration Example

I. Network requirements
In the network, some hosts use FE80::10 as their default gateway and some hosts
use FE80::20 as their default gateway.
Load sharing and mutual backup between default gateways can be implemented
by using VRRP standby groups.
II. Network diagram
Figure 1-12 Network diagram for multiple VRRP standby group configuration
III. Configuration procedure
1) Configure Switch A
# Configure VLAN 2.
<SwitchA> system-view
[SwitchA] ipv6
: UP
: 100
: YES
: SIMPLE TEXT
: FE80::10
: 0000-5e00-0201
: FE80::2
1-36
Chapter 1 VRRP Configuration
State : Master
Run Pri : 100
Delay Time : 5
Key : hello