Page 1
PLEASE READ BEFORE RETURNING THIS PRODUCT FOR ANY REASON. If you have a question or experience a problem with your BLACK+DECKER purchase, go to www.blackanddecker.com/instantanswers If you can’t find the answer or do not have access to the Internet, call 844-299-0879 from 10:30 a.m.
Voltage: 120V, 60Hz Power Consumption: 1500W Unit Size (WxDxH): 6.3” x 6.8” x 21.7” PRODUCT REGISTRATION Thank you for purchasing our BLACK+DECKER product. This Model number easy-to-use manual will guide you in getting the best use of your heater. Serial number Remember to record the model and serial numbers.
SAFETY INFORMATION DANGER WARNING CAUTION DANGER - Immediate hazards WARNING - Hazards or unsafe CAUTION - Hazards or unsafe which WILL result in severe practices which COULD result in practices which COULD result in personal injury or death severe personal injury or death minor personal injury IMPORTANT SAFETY INSTRUCTIONS WARNING...
Do not attempt to modify the plug in any way. NOTE: Neither BLACK+DECKER nor the dealer can accept any liability for damage to the product or personal injury resulting from failure to observe the electrical connection procedures.
Page 6
SAFETY INFORMATION OVERHEAT SAFETY FEATURE This heater is equipped with a overheat safety feature. When the heater’s internal components reach a certain temperature that could cause overheating and possible fire, the heater will automatically shut off. If this should occur, please contact our Customer Satisfaction Center at 844-299-0879.
SET UP & USE OPERATING INSTRUCTIONS Place the heater on a firm, level surface and plug the unit directly into a 120 V AC electrical outlet. When the heater is plugged in it will be in standby mode. Press the POWER button on the heater or the remote control to start the heater.
Page 9
SET UP & USE TIMER FUNCTIONS Delay Start When the heater is in standby mode press the button to enter the number of Timer hours you would like the heater to start by pressing to increase and to decrease by one hour each time the button is pressed.
Page 10
SET UP & USE DO NOT COVER Down Power Mode Timer Oscillating Button Air Flow Page 10...
Page 11
SET UP & USE REMOTE CONTROL Battery Installation (batteries not included) 1. Push the button next to the battery cover to release the battery cover. 2. Insert 1 x CR2032 type lithium battery (not included), making sure “+” side is facing up as shown in the diagram.
CARE & CLEANING MAINTENANCE 1. Turn power off before cleaning. 2. Unplug the unit and let it cool completely. 3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth.
TROUBLESHOOTING & WARRANTY If the Digital Display indicates an error code of E1 or E2 this indicates an issue with the temperature sensor. Unplug the heater and contact W Appliance Co. Customer Satisfaction Center at 844-299-0879 or service@equitybrands.com BEFORE YOU CALL FOR SERVICE IF THE HEATER/FAN FAILS TO OPERATE: A) Check to make sure that the heater/fan is plugged in securely.
TROUBLESHOOTING & WARRANTY LIMITED WARRANTY Any repair, replacement, or warranty service, REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF and all questions about this product should be THE CUSTOMER; W Appliance Co. SHALL NOT BE directed to W Appliance Co.
Page 15
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
Page 16
BLACK & DECKER, BLACK+DECKER, the BLACK & DECKER and BLACK+DECKER logos and product names and the orange and black color scheme are trademarks of The Black & Decker Corporation, used under license. All rights reserved. Product in this box may differ slightly from that pictured. Does not affect function.
Need help?
Do you have a question about the BHVHC15 and is the answer not in the manual?
Questions and answers
The blower is having trouble starting.
The Black+Decker BHVHC15 blower might have trouble starting due to the following reasons:
1. Not securely plugged in: Ensure the heater/fan is plugged in securely. If not, unplug it, wait 10 seconds, and plug it back in securely.
2. Blown circuit fuse or tripped breaker: Check for a blown circuit fuse or a tripped main circuit breaker.
3. Faulty outlet: Test the outlet with another appliance to ensure it is functioning.
If these steps do not solve the issue, contact a qualified technician. Do not attempt to adjust or repair the appliance yourself.
This answer is automatically generated