Sony SLV-E730EX/UX Operating Instructions Manual page 21

Setting up VIDEO Plus+ for satellite broadcasts
When your satellite tuner is connected via the AERIAL IN connector, first
you have to set the programme position for each satellite channel using the
TUNER menu. Then set the guide channel number for each satellite channel
using the VIDEO PLUS+ menu.
If your satellite tuner is connected via the LINE-1 (TV) connector, you don't
have to set programme positions nor guide channel numbers for satellite
channels. Skip the following procedure.
1
Turn on the satellite tuner.
2
Press MENU, then select SETTINGS and press the joystick (OK).
3
Select TUNER, then press the joystick (OK).
4
Press PROG +/– to select a programme position you want to use for
watching a satellite channel.
5
Select CHANNEL SET, then push the joystick to ?// repeatedly to
tune the VCR to the satellite tuner.
The channel number displayed beside
CHANNEL SET is used for receiving all
satellite broadcasts from the satellite tuner.
Remember this number for the following
steps.
6
Press PROG +/– to select another programme position for the next
satellite channel, and press the programme number buttons to enter the
same channel number as the one displayed in step 5. Otherwise, the
setting will not be memorized.
Repeat this step for all satellite channels, then press the joystick (OK).
7
Set the guide channel number for each programme position assigned to
the satellite channel, following the procedures on page 18.
Notes
• The menu disappears automatically if you don't proceed for more than a few
minutes.
• If you use a satellite tuner connected via the LINE-1 (TV) connector, you don't have
to set up VIDEO Plus+. Just record a satellite programme using VIDEO Plus+, and
the VCR automatically records the programme from the LINE-1 (TV) connector.
• If you inadvertently entered a guide channel number, press CLEAR.
• The VCR does not allow entering the guide channel number if the same number
has been set.
• When you record a satellite broadcast using VIDEO Plus+, you need to select the
desired channel on the satellite tuner manually.
TUNER PROG 6
NORMAL / CATV [ NORM ]
CHANNEL SET [ C 3 0 ]
AFT [ ON ]
FINE TUNING
SELECT :
SET :
Getting Started
21