Table of Contents
Advertisement
A/V hookup:
After you've connected your TV and completed antenna or cable hookup,
use the following procedure to set up the VCR.
Press MENU and select
ADVANCED OPTIONS.
TIMER SET/CHECK
SETTINGS
ADVANCED OPTIONS
SELECT
:
:
SET
O K
QUIT
:
MENU
Caution
Connections between the VCR's VHF/UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure to
do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
connect the output of the VCR to an antenna or make simultaneous (parallel) antenna
and VCR connections at the antenna terminals of your receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer's attention to Article 820-
40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
VCR setup
,
Set AUTO ANT SELECT
to OFF and press OK.
ADVANCED OPTIONS
AUTO ANT SELECT
ON
AUTO STEREO
OFF
TUNER AUDIO
APC
ON
TAPE SELECT
AUTO
AUTO TAPE SPEED
ON
SHARPNESS
L
3RETURN
SELECT
:
:
SET
O K
QUIT
:
MENU
For details, see page 54.
H
continued
9
Getting Started
Advertisement
Table of Contents
