Advertisement
Fig.4
4.3.
CHISEL AND PLANE SHARPENER (Refer to fig.4)
4.3..1.
Slide module labelled "Chisel and Plane Sharpener" onto the power unit and ensure protective shield is in position.
4.3.2.
Place the blade against the back lip of the plate (bevelled side downwards) (3a). The magnet helps hold it in place.
4.3.3.
The sharpening angle must match the existing bevelled angle on the blade tip (3b).
4.3.4.
To alter the angle, loosen the angle adjusting knob (3c), adjust the plate angle, then retighten.
4.3.5.
Make sure the blade edge touches the grinding wheel, then switch the power unit on.
4.3.6.
Slide the blade and plate with light, steady pressure back and forth across the grinding wheel in a continuous motion (3d).
DO NOT hold the blade stationary as this causes irregular sharpening.
4.3.7.
Gradually adjust the blade down the plate while sharpening (3e). DO NOT press hard, grind gradually, repeat this step.
4.3.8.
Remove the blade and make sure the bevelled edge and tip are evenly sharp. If not adjust the grinding angle.
IMPORTANT! The sharpening angle must match the existing bevelled angle of the blade. This avoids removing too much metal
unecessarily and keeps the blades at their optimum shaving angle (3f).
4.3.9.
When sharpening thin chisel blades, place the small chisel guide (4) onto the plate to act as a spacer and sharpen as before (3g).
4.3.10.
Switch the power unit off. Before removing the module, ensure that the grinding wheel has stopped.
4.3.11.
It is recommended that after grinding, the blade tip is honed on an oil stone.
5.
MAINTENANCE
5.1.
Before cleaning disconnect from the mains. Keep clean and free from oil and grease, store in dry conditions.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without
prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Ltd
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
SMS2004
Issue:4 (H,F) - 22/01/18
Advertisement
