Advertisement
To allow the bracket frame to sit flush with
the wall, and to allow the dog-ears to swing
easily into place, trim any rough interior or
exterior edges of the drywall opening.
*This step will have already been done if a
rough-in ring has been installed.
Max Length
80 Feet
WIRING PLACEMENT
Install the Charging Adapter: The USB to
CAT5E charging adapters are designed to
be used with the power adapter and
charging cable that came with your tablet.
Using a terminated CAT5E patch cable you
can extend the ability to charge your tablet
up to 80 feet (Do not exceed without POE
injection - not included).
Connect the USB (male) charging adapter
to the wall plug that came with your tablet,
and to the Ethernet patch cable. Connect
the other end of the patch cable to the USB
(female) charging adapter. Connect the USB
cable that came with your tablet to the
charging adapter and secure both the USB
and patch cables to the back of the
Padimount
in-wall
included P-clamps. Leave enough slack in
the cable to connect your tablet and route
the end of the cable through the opening in
the bracket frame.
Install the In-Wall Bracket: Remove the
steel faceplate, as well as the plastic
retaining ring, and set them aside.
padi m ount.c om
bracket
using
the
IN-WALL BRACKET
Allen Wrench
Place the in-wall bracket in the cutout
opening, taking care not to kink the
charging cable. Making sure the frame is
level; carefully tighten each of the dog-ear
screws around the perimeter to secure the
frame. As you tighten each dog-ear it will
swing into place and begin to clamp the
frame to the drywall. It is important not to
over tighten any of the dog-ears, as this may
warp the bracket and make it difficult to
install your tablet later.
REMOVE
If the opening in the drywall is obstructed by
a wooden stud or other obstruction, it may
be necessary to remove one or more of the
dog-ears. If this occurs, use one of the
included mounting screws to secure the
Advertisement
