Padimount A7 Installation Instructions

Introduction:
Your Padimount in-wall tablet mount was
designed to securely and elegantly mount
your tablet to the wall. It is thin enough to
mount over a stud in drywall as thin as 1/2".
It comes with either a fingerprint resistant
stainless steel, or a paintable white outer
frame. The kit includes a USB over CAT5E
power extender, as well as all necessary
mounting hardware and accessories.
Contents:
(1) Assembled Bracket / Frame
(1) Retaining Ring with Neodymium
Magnets
(1) Decorative Faceplate
(1) USB (male) to RJ-45 (female) Charging
Adapter
(1) USB (female) to RJ-45 (female)
Charging Adapter
(1 set) P-Clamps with Screws
(1 set) Security Screws
(1 set) Mounting Screws
(1) Instruction Manual
(1) Cutout Template
(1) 2.5mm Allen Key
Placement*: Determine if you will be
mounting your tablet
vertically. Using the faceplate as a guide,
locate the position on the wall where the
mount will be installed. Because of the
shallow depth of the Padimount in-wall
bracket, it is not necessary to limit
placement only to areas between studs.
The in wall bracket is designed for use in
locations where 1/2" or 5/8" drywall has
been installed. In locations where other
building materials have been used it may be
necessary to use the included mounting
screws to install the bracket.
Measure and mark the center point of the
location you have chosen.
*This step will have already been done if a
rough-in ring has been installed.
Cutting the Opening*: Using a level,
center and place the included cutout
template over the center point, making sure
to
(horizontal or vertical) of the tablet. Mark and
cut the opening using the appropriate tool,
taking care not to damage any wiring,
plumbing or ductwork inside the wall.
horizontally or
Center Over Mark

Installation Instructions

IN-WALL BRACKET PLACEMENT
Approx. Center
maintain the correct
Cut Around Tracing
with Drywall Saw
I W B - A 1 0
C u t o u t Te m p l a t e
Trace Around Template
CUTOUT TEMPLATE
orientation