Download Print this page

Tanox WeldGuard ADF-206S Replacig The Battery

Hide thumbs Also See for WeldGuard ADF-206S:

Download this manual See also: User Manual

ADF-206S - Replacing the Battery

Its easy replacing the battery as you will see in the

following manual:

before you do that please note the following:

1st - it would be easier if you first remove the head band

2nd - while following the next steps please be gentle and

if there are things you're not sure of please ask before

doing, it's always better to be on the safe side...

Page 1 ADF-206S - Replacing the Battery Its easy replacing the battery as you will see in the following manual: before you do that please note the following: 1st - it would be easier if you first remove the head band 2nd - while following the next steps please be gentle and if there are things you're not sure of please ask before doing, it's always better to be on the safe side...
Page 2 Replacing the battery 1- pinch the 2 buttons in the direction of the arrows...
Page 3 2- while keeping the pressure, lift the filter case up a bit as in the following image...
Page 4 3- Release the case from the other side as in the next image...
Page 5 4- Now the Filter is still inside the filter case but is removed from the helmet connectors.
Page 6 5- Release the filter from the left holding pin...
Page 7 6- Release the filter from the right holding pin...
Page 8 7- Now the battery compartment is visible...
Page 9 8- Replace the battery and connect everything back...